Concrete mixer is the main equipment for producing concrete. Concrete mixer is a machine that mixes cement, gravel aggregate and water into concrete mixture. Pay attention to daily maintenance during use. If you don't pay attention to maintenance, axle holding may occur. There are many reasons for axle holding of concrete mixer.
1. The concrete mixer may be due to the feeding position of raw materials. The materials used for mixing concrete are mainly sand and gravel aggregate, cement, fly ash, water and drinking admixture, etc. If the raw cement is wrapped with sand and stone and agglomerates with water, it is easy to stick to the mixing shaft if it is not fully stirred. If the position and direction of the cement feed inlet is unreasonable, the mixing shaft cannot be quickly and fully stirred, and it is easy to form the phenomenon of shaft holding.
2. Reasons for water inlet pipe and flushing position of concrete mixer. If the position and direction of the flushing point are incorrect, or the flushing pressure is too low, so that the water cannot flush the concrete temporarily bonded to the shaft after entering the main engine, it is easy to form the shaft holding after a long time.
3. For the concrete mixer, the interior of the concrete mixer is not cleaned in time after the structural production, or the cleaning is not clean, resulting in the residual concrete on the surface of the mixing shaft, which is solidified on the mixing shaft after drying. If this is the case for a long time, it is very easy to produce the phenomenon of shaft holding.
The above is a detailed introduction of the automatic mixing machine. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.shanqijituan.cn/